You'll be ready to stream in just five minutes!
TRIPOD AND CAMERA MOUNT (watch the video)
1.0 Tripod Setup
- 1.1 Remove the quick release plate from the top of the tripod (A) by loosening side knob and sliding out the plate by depressing the blue button on the side.
-
1.2 Screw Mount (B) onto quick release plate, with the round magnet facing you on the tripod-handle side (a nickel is useful for tightening the screw).
- 1.3 Replace and secure quick release plate by sliding past blue button and tightening side knob.
LENS AND CABLES (watch the video)
2.0 Connect the Lens & Audio Cables to Camera
-
2.1 Align tabs on the small end of the telephoto lens (C) with the slot running
across the middle lens of the camera's protective case. Insert the lens into the
slot and give it a quarter turn to lock it into the case. -
2.2 Insert the grey end of the red curly cable into grey Audio and Power (D)
adapter. Insert adapter's USB-C connector into the USB-C port in the end of
camera.
ASSEMBLY
3.0 Mount Camera & Connect Mic Receiver
- 3.1 Attach the camera to round magnetic mount
- 3.2 Plug black end of red cable into the mic receiver (the block with a screen)
-
3.3 Slide mic receiver clip into 'cold shoe' mount at the top of the camera
mount (E)
AUDIO
4.0 Place your Wireless Microphones
- 4.1 Hold down Power Button (Ø) on the Microphone Transmitters until blue lights come on, and on the Receiver until screen illuminates.
- 4.2 Attach one Microphone transmitter to the top of the podium's gooseneck Microphone.
- 4.3 Place the other Transmitter between 24"-36" from an audio speaker in the room or a musician.
- 4.4 Mics may also be clipped to the clothing of participants or held by hand like a Microphone. Please remember that once the ceremony begins, the mic will be live throughout the stream.